When installing the device, please follow the steps below: place the bag filter on the station to be filtered, connect it to the inlet and outlet flanges or pipe teeth, and fix it; plug the exhaust port or configure the exhaust valve. Jacket type connects heat insulation heat source. Put the metal inner net quietly into the bag filter, so that the neck of the inner net matches the bag filter mouth.

 

Place the filter bag so that the ring mouth of the filter bag matches the neckline of the metal inner mesh. Put the Ο-type sealing ring into the Ο-type groove. The Ο-type sealing ring cannot be twisted or deformed. The multi-bag filter presses the filter bag pressure ring. Hold the handle of the upper cover with one hand, grasp the other end of the upper cover with one hand (multi-bag filter turns the top hand wheel) After the upper cover is aligned, tighten the two diagonal caps at the same time, tighten all caps one by one The rod is inserted into the ring and tightened).

 

Close the exhaust valve at the top of the bag filter. Please check whether each connecting pipe is strong; whether the working pressure is within the allowable range. Open the output valve. Turn the heat source inlet valve, the temperature of the filter rises to the specified temperature. Open the input valve slowly to allow the liquid to slowly flow into and overflow the filter, to avoid the liquid suddenly hitting the filter bag, forming a break, and then check for leaks. If there is no leakage, you can start filtering.